Tender No: MC/S461/2473/26/1
1 DESIGN PHASE: Fabrication and supply of replica Helicopter Cockpit Shell for Full Motion Simulator 02 sets
2. PRODUCTION PHASE: Fabrication and supply of replica Helicopter Cockpit Shell for Full Motion Simulator 04 sets
Development phase sets will be handed over in 11 months
Production phase:
2027-28 01 Set
2028-29 02 Set
2029-30 01 Set
LCH Full Motion simulator
FMS would be used as a training aid for pilots to impart training on missions performed by the helicopter i.e., take-off, landing, route & instruments flying, navigation, emergency procedures, etc. The helicopter is a twin-engine, dedicated combat helicopter featuring a narrow fuselage with tandem seating configuration for Pilot and Weapon System Operator (WSO). To meet the operational and mission training requirements, One FMS will have 02 Nos. of Simulators i.e. 01 No. of Pilot Simulator and 01 No. of WSO Simulator. Each Simulator shall be equipped with its own dome based Multi-Channel Projection System along with cockpit, motion, vibration, control loading system, etc.
Floor shall be rigid enough to sustain loads of approximately 800 Kg of Weight (Pilot Seat assy.: 200 Kg, Pilot Weight: 100 Kg, console assy.: 200 Kg, flight controls and its assemblies:300 kg. etc). Vendor to maintain sufficient structural margins to meet motion platform requirements.
Simulator will have: Seat, Emergency Axe, First Aid Box, Rotor Brake Hand Pump, Map Box, Roller Curtain Side, oxygen cylinder, wind screen wiper, fire extinguisher, RADMAC Unit , Cockpit Mic, EO Grip, Pilot Bottom Armour Panel, Pillar Lamp, LH Console, RH Console, Main Instrument Panel, pedal assembly front cockpit, pedal assembly rear cockpit, collective controls, cyclic controls, Neutral Lock Assembly, Parking brake Asembly

