Defence Research and Development Organisation (DRDO) : News and Updates

One lrde tender about navigation radar related items

1686755897125.png

1686755950785.png

1686755911265.png
 
This was where the presentations were shown today.

‘G20 – S20 Meet’ at IIT-Mandi focuses on collaboration among DRDO, DPSUs and armed forces for technological advancement in defence sector


 
  • Like
Reactions: marich01
New directors appointed at ASL &RCI

BV Papa Rao takes charge as Director of ASL, DRDO. Anindya Biswas at RCI.



 
Last edited:
  • Like
Reactions: Fatalis
Neat mfg research paper from DMRL people, only the abstract is freeview though. A Venugopal Rao is senior & has some good papers this year

Precision milling of nickel-based single-crystal superalloy by TiAlN coated small diameter solid carbide end mill
Nickel-based superalloys pose cutting challenges due to their high strength, hot hardness, work hardening, and low thermal conductivity. Precision milling with small cutters is used for complex shapes and intricate profiles, but selecting appropriate machining parameters for these alloys is a challenging task. A set of machining conditions in slot milling with a TiAlN coated 1.5 mm diameter solid carbide end mills are investigated for dimensional accuracy, cutting forces, and specific energy. The dimensional accuracy in depth consists of within 10% of the depth of cut. The axial force and the feed force increase from 20 N to 106 N and from 17 N to 46 N, respectively with an increase in chip area from 0.8E-03 to 1.5E-03 mm2/rev. Tool rotation caused a gradual increase of cutting forces in up-milling and decreasing of cutting forces in down-milling. The specific energy increases from 393 to 865 J/mm2 steeply under higher chip areas.


 
  • Like
Reactions: Rajput Lion